Endura Flap Single Flap Pet Door For Doors (2022 Design) - Installation Instructions

Difficulty High

Steps 14

Time Required 2-3 hours

Sections 06

Flags 03

Please read instructions & notes thoroughly before installation.

Single Flap Door Mount

If you have not yet measured your pet, watch this video to ensure the pet door will work.
If possible, remove the door from its hinges using a screwdriver and hammer to tap out the hinge pins. Lay the door flap for installation. Tape the provided template to the door. The top edge of the cut-out line should be at least 3” (7,6 cm) above the pet's shoulders.
Be careful not to cut too close to the bottom of the door as you may reduce the door's strength. Level the top edge of the cut-out line.

Once you are certain the pet door will work with your door, make sure the template is level, and mark the outline with a pencil. Remove the template and drill holes through the corners just inside of the lines using a ⅜” (9,5 mm) drill bit.
Make sure your drill is kept level and drills all the way through the door.

Using a jigsaw, cut along the marked lines, making sure to cut straight.
We recommend applying masking tape along the outside of the lines to protect your door from scratch marks as you cut with the jigsaw.

Ensure the weatherstripping is firmly pressed in the groove on both frames. Weatherstripping indicated in red.

Place the trim frame on the outside of the door and the flap frame on the inside.

Select appropriate screws and insert them into the pet door from the inside.
Do not fully tighten screws until all four screws are inserted and the pet door is leveled.
Use the included installation magnet to help align the screws.

Door Width	Screw Length
1-⅜” (3.5 cm)	Short Screws (1-¾”)
1-¾” (4.4 cm)	Long Screws (2-¼”)

Once the pet door is leveled, tighten the screws so that the weatherstripping compresses.
Do not overtighten.

Apply silicone where the two frames meet. Also apply silicone where the outside frame meets the door.