Endura Single Flap Door Mount (E2 Design) - Replacement Flap Instructions

Installation Instructions

Click to view the Double Flap Door Mount Replacement Flap Instructions.

Difficulty Easy

Steps 06

Time Required 0.5 Hours

Sections 01

Flags 05

Parts

1 Replacement Flap
3 Retainer Rings
4 Hole Plugs*

Tools

Magnetic Phillips head #2 screwdriver
Flat head screwdriver
Drill

*Replacement flaps come with two sets of hole plugs, but you will only need to use one on your flap. For your door, use the smaller 4 hole plugs and discard the larger set of 8.

Step 1 REMOVE THE SCREWS

Remove the screws from the interior frame with the Phillips head screwdriver.
As needed, cut through any caulking to remove the frame you are replacing the flap for.

Step 2 REMOVE THE FLAP ROD

Look for a metal rod at the top of the flap frame—remove one of the circular metal retaining rings by forcing it off with a flathead screwdriver.
You only need to remove one retainer ring.
Push the metal rod through the flap frame until it comes out on the other side. Pull the rod out and remove the flap.

Step 3 REPLACE THE FLAP

Position the new flap in place in the frame and make sure the magnets are attracting correctly. If they are not, try flipping the flap around (switching the interior and exterior faces).
Sometimes the bellows (accordion-like sides of the flap) contract during shipping and prevent the magnets from attracting. To fix this, remove the pivot washers from the top corners of the flap and use a blow dryer to lightly heat the bellows and stretch them back out.

Step 4 REINSTALL THE ROD

Guide the metal rod back through the flap and frame.
Push a new retainer ring on by holding the other side of the rod in place while pushing the ring on with your fingers.
Each side only needs one ring, and the teeth need to be bent facing away from the flap. If you’re having difficulties putting the new ring on, try flipping the ring around so the teeth are facing the opposite direction.

Step 5 REINSTALL FLAP ASSEMBLY

Reinstall the flap assembly into the opening, then screw them into place.
Do not overtighten.
Install the included new set of hole plugs by pressing them on by hand.
Use the set of 4 smaller hole plugs only; discard the set of 8 larger hole plugs.
Do not caulk the bottom edge of the outside frame. This provides water drainage for the unit.